Lights bar and lights
Light bar mount
Piece of 2x2 alum angle. Stainless clamps are used to hold to the bar. This pic shows the bracing clamp. Mounted are a pair of Hella 500s. Ugly lights. But they show up as very big and bright.
Starboard side of mount. I will probably cover in carbon fiber to make it look better.
top view of cable harness going into port side of tank. Use a coat hanger to fish it through so I did not have to take the tank off.
Top port side
Under tool tray. drilled hole in left side of box to bring harness and battery supply in.
Piece of 2x2 alum angle. Stainless clamps are used to hold to the bar. This pic shows the bracing clamp. Mounted are a pair of Hella 500s. Ugly lights. But they show up as very big and bright.
Starboard side of mount. I will probably cover in carbon fiber to make it look better.
top view of cable harness going into port side of tank. Use a coat hanger to fish it through so I did not have to take the tank off.
Top port side
Under tool tray. drilled hole in left side of box to bring harness and battery supply in.
posted by Kelly at 9:03 AM
1 Comments:
There is a relay under the tool tray. It is wired to the battery. The switch wire (at the bars) takes power from the stock relay (I think headlight) that is under the tool tray also. There is a wire that turns off with the key. This turns the lights on and off with the keys.
Then just run power from the relay to the lights. It is run in the plastic tubing that was installed on the right side of the gas tank.
Post a Comment
<< Home